Datamax I-4208 User Manual download pdf (Page 28)

18 I-Class

3.1.1 Roll Media

This loading method is for roll type media applications. To load:

n Slide the Roll Media

onto the Media Hub

until it rests against the

Backstop.

o Route the media as

shown: under the

Media Idler, through

the Media Sensor, then

out the front of the

printer.

p Raise and slide the

Media Guide over until

it rests lightly against the edge of the media.

q Position the Media Sensor; see Section 3.2.

r If your application uses thermal transfer media, load ribbon (see Section

3.3); otherwise continue.

s Lower the Printhead Assembly and rotate the Printhead Latch completely

back into the locked position. Close the Access Cover.

t Turn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEED

Key until at least one label gap or mark is advanced; see Section 3.4.

☞

If using less than full width media, adjust the Leveling Cam; see

Section 5.1.1.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 145 146

No comments

Datamax I-4208 User Manual Page 28